#DELL PHOTO 944 PRINTER SOFTWARE SOFTWARE#
Remanufactured ink cartridges, the best thing to do is to disable “ink alerts” on the printer’s software so you don’t keep Since the sensors are fuses that open when the ink level drops, they cannot be reset. The “Low Ink” is usually the last sensor (fuse) before Most ink cartridges have sensors that report the ink level. Why my printer is reporting “low ink" after using refilled/remanufactured ink cartridges? This post is in no way a validation of refilling ink cartridges. Refilling ink may lead to print quality problems, and even eventual hardware problems. Buying or replacing ink cartridges with new Dell cartridges will resolve the low ink message.ĭell discourages ink refills. If you refill an ink cartridge that previously reported low ink, it may print fine, but the sensor will always Why does my Dell ink cartridge level still show up as "low ink" after refilling them?ĭell ink cartridges have a sensor that reports the ink level as low once it reaches a certain level. Close the printer and it should print an alignment page.
#DELL PHOTO 944 PRINTER SOFTWARE SERIES#
Take out both Dell Series 5 ink cartridges and make sure the tape is off the cartridges and insert both back in and make sure the seat properly and latch. Now open the printer with the power on and the cartridges should go to the center to be replaced. This will reset any error messages the printer has. Now remove the power brick from the back of the printer for 60 seconds. 98% it's the cartridge that's causing the issue. Worst case scenario the contacts on the printer carrier might be broken already.īut in this kind of situation. try the steps on the color cartridge as well, it might be with the color cartridge error. If the old cartridge is also giving same error. If the old cartridge still works, you need to contact dell for the replacement of the black cartridge (if you purchase the black cartridge from dell) If you still have same error code, try the old cartridge. close the carrier, plug the power cable back in. gently wipe the contacts of the black cartridge carrier (where you put the black cartridge in). gently wipe the copper strip of the cartridge. SOURCE: Dell 944 error message 1102 after fitting new DellBlack Cartridge
0 kommentar(er)
